NET S8+
Description
 |
 NET S8+ |
|
| MODEL:NET S8+ | ||
| Product Introduction: | ||
| ·Proven and dependable Maxwell 6 chip (Pacific Crest BD970 motherboard) technology ·220 channels and unmatched GNSS multi-constellation tracking performance |
||
Downloads: NET S8+_Brochure.pdf |
● Proven and dependable Maxwell 6 chip (Pacific Crest BD970 motherboard) technology
● 220 channels and unmatched GNSS multi-constellation tracking performance
● Convenient front control panel display for clear view and easy configuration
● Compact housing with a variety of interfaces for different external devices access
● Powerful remote control capability for access, configuration, programming, data download, reboot/restart, firmware upgrade, code registration, etc.
● Large capacity internal memory and expendable RAM for long-term massive data storage
● Smart Auto-Reset function for restoring earlier parameters automatically after power-off recovery
● Integrated battery serves as either the primary power source or the stand-by Uninterrupted Power Supply (UPS) backup
● Powerful built-in web user interfaces provide full information such as receiver status, configuration, firmware update and data access, and support a variety of security levels and access control
● Static data downloading accessible (when authorized) anywhere, no longer restricted in data control center only
User-friendly web interfaces
USER INTERFACE
CHOKE RING ANTENNA
|
NET S8+ |
|
| MODEL:NET S8+ | ||
| Product Introduction: | ||
| ·Proven and dependable Maxwell 6 chip (Pacific Crest BD970 motherboard) technology ·220 channels and unmatched GNSS multi-constellation tracking performance |
||
Downloads: NET S8+_Brochure.pdf |
Measurements
General Info
·220 channels, by advanced Pacific Crest Maxwell 6 Custom Survey GNSS technology
·High precision multiple correlator for GNSS pseudo range measurements
·Unfiltered, unsmoothed pseudo range measurements data for low noise, low multipath error, low time domain correlation and high dynamic response
·Very low noise GNSS carrier phase measurements with 1mm precision in a 1Hz bandwidth
·Signal-to-Noise ratios reported in dB-Hz
·Proven Pacific Crest low elevation tracking technology
Initialization typically<10 seconds
Initialization reliability >99.9%
Satellite signals tracked simultaneously
- GPS: L1 C/A, L2E, L2C
- GLONASS: L1 C/A, L1 P, L2 C/A (GLONASS M only), L2 P
- SBAS: L1 C/A
Code differential GNSS positioning
Horizontal 25mm+1ppm RMS
Vertical 50mm+1ppm RMS
SBAS positioning accuracy <5m (typically) 3DRMS RMS
Static GNSS surveying
Baseline <30km
Horizontal 2.5mm+0.5ppm RMS
Vertical 5mm+0.5ppm RMS
Baseline >30km
Horizontal 4mm+0.5ppm RMS
Vertical 9mm+0.5ppm RMS
Real-time Kinematic surveying
Single base <30km
Horizontal 10mm+1ppm RMS
Vertical 20mm+1ppm RMS
Network RTK
Horizontal 8mm+0.5ppm RMS
Vertical 15mm+0.5ppm RMS
Hardware
Data Communication
·RS232 (9 pin) serial port, supports Host Computer mode operation
·Fully integrated and sealed 2.4GHz communication Bluetooth module
·Ethernet protocols: HTTP, HTTPS, TCP/IP, UDP, FTP, NTRIP,
·Supports Proxy server and routing table
Data storage and output
·Data storage: 4GB internal SD card, ready for cycle recording raw data up to 12 months (5s per epoch), extendable to industrial-level 16GB SD card. And the indirect USB interfaces are available for external storage device.
·Positioning output: 1Hz, 2Hz, 5Hz, 10Hz (dependent on setup option), up to 50Hz (supported by mainboard Bd970)
·Reference output: CMR, CMR+, RTCM2.1, RTCM2.2, RTCM2.3,
RTCM3.0, RTCM3.1
·Navigation output：ASCII: NMEA-0183 GSV, AVR, RMC, HDT, VGK,
VHD, ROT, GGK, GGA, GSA, ZDA, VTG, GST, PJT, PJK, BPQ, GLL, GRS,
·GBS and the binary: TrimbleGSOF
Electrical
·DC input 9.5V-15V, with over-voltage protection
·Low power consumption 4.0W
User Interface
·Front panel display with buttons and LED screen
·One RJ45 Ethernet port (10M/100M), supports TCP/IP, HTTP, Ntrip protocol (supported by mainboard Bd970)
·Two RS232 data ports, transmit static data and differential correction data
·Two multi-functional ports: Port 1 supports system debugging and static data download from internal SD card; Port 2 supports parameters configuration and connecting meteorological sensor/barograph/inclinometer as well as external storage disk to extend storage capacity
·One external frequency scale port, supports high-precision atomic clock connection
·One PPS output port
·One event marker input port
Physical
·Dimension (L×W×H): 202mm×163mm×75mm
·Weight: 1.4kg
·Shock: rugged aluminum case plus plastic ring seal, designed to
survive a 1m drop onto hard surface
·Tested to IP67 standard: waterproof for temporary immersion to a
depth of 1m; dustproof
Environmental
·Temperature: -40℃~75℃
·Humidity: RH (relative humidity), 10％～95％(non-condensing)
Remarks
Measurement accuracy and operation range might vary due to atmospheric conditions, signal multipath, obstructions, observation time, temperature, signal geometry and number of tracked satellites.
Specifications subject to change without prior notice.
DEVICES CONNECTIO